Example · 3D modeling
Phone stand for 3D printing
A parametric model: width, tilt, lip height and wall thickness are set as numbers, and the model rebuilds for a specific phone. Rotate it with your mouse or finger.
Rotate: drag · zoom: mouse wheel or two fingersDrag to rotate · pinch to zoom
The 3D preview did not load. You can download the model below or look at the profile drawing.
Specifications
- Dimensions
- 70 × 93.5 × 86 mm
- Back tilt
- 65°
- Phone slot
- 14 mm
- Wall thickness
- 4 mm
- Volume
- 59 cm³
- PLA plastic
- up to ~73 g
- Format
- STL, millimeters
How to print
- Lay it on its side, flat face down on the bed: no supports needed.
- 0.2 mm layers, 3–4 perimeters, 20–30% infill.
- The mesh was checked in code: it is watertight and ready for a slicer.
Profile drawing
The stand is 70 mm wide. All dimensions can be changed at the top of stand.py, then rebuild the model with python stand.py.